URFACE PREPARATION AND APPLICATION CYCLE

Steel Sandblast to grade SA 2.5. Apply one coat of EPOFOND AM/9 primer. After 12 hours, sand with medium-grit sandpaper and apply DECK FILLER 91. Allow to dry for 36–48 hours. If needed, apply PLAMUR FINISHER LIGHT to achieve a perfectly level surface. Sand and proceed with the chosen finishing cycle.

Aluminum and light alloys Mechanically remove the oxidized surface layer. Remove dust and surface residues, then degrease with Thinner 765. Apply one coat of EPOFOND AM-9 primer. After 12 hours, apply DECK FILLER 91 and let it dry for 36–48 hours. If necessary, apply PLAMUR FINISHER LIGHT for perfect leveling. Sand and proceed with the chosen finishing cycle.

Fiberglass The surface must be dry, well-degreased, and lightly sanded. Apply one coat of EPOFOND AM/9. After 12 hours, apply DECK FILLER 91 and allow it to dry for 36–48 hours. If needed, apply PLAMUR FINISHER LIGHT to achieve a perfectly smooth surface. Sand and proceed with the selected finishing cycle.

New or restored wood The surface must be dry, clean, and dust-free. Apply 2–3 coats of EPOWOOD or POLIGLASS varnish, sanding between each coat. Then apply one coat of EPOFOND AM-9 primer. After 12 hours, apply DECK FILLER 91 and allow to dry for 36–48 hours.

Note: This product is also part of the Skipper’s Nautical Line. For more information about this sector, please refer to the complete painting cycles for boats made of Wood, Steel, Aluminum, or Fiberglass, available upon request.