Fillers
Home - Products - Marine Line - Yachting Line - Fillers - AM Floor
AM Floor

AM Floor

pdf-icon
Code: 7F6450 sol a + 8z6451 sol b

Self-leveling two-component epoxy coating designed for industrial flooring. Once fully cured, it withstands mechanical movements excellently, without issues of thickness loss or cracking. It can be overcoated, if necessary, with two-component finishes to meet specific requirements (gloss, matte effect, slipperiness or anti-slip properties).

SURFACE PREPARATION AND APPLICATION CYCLE

Cement, cement-based conglomeratesThe substrate must be clean, dry, properly cured, free from loose particles, efflorescence, and release oils. Apply a coat of EPOFOND AM/9 as a primer, diluted according to the absorbency of the concrete. Allow to dry, then apply AM/FLOOR-EPOXY to achieve the desired thickness (from 1 mm up to a maximum of 10 mm). If an aesthetic finish is required, apply 2 coats of polyurethane enamel.

Existing floors in concrete, cement, ceramic, and natural stones

Make sure the substrate is clean, dry, compact, and free from loose particles. If necessary, fill visible defects (holes, cracks, or deep fissures). Apply a coat of EPOFOND AM/9 as a primer, diluted just enough to consolidate the surface. Allow to dry, then apply AM/FLOOR-EPOXY to the required thickness (from 1 mm up to a maximum of 10 mm). If an aesthetic finish is required, apply 2 coats of polyurethane enamel.

Note: Do not dilute the product with solvent, as this could cause curing problems and bubble formation over time.

Paint Type Two components
Binder type A Epoxy modified
Code & colour A 7F6450 neutral grey
Code & colour B 8Z6451 amber
Specific gravity kg/lt (±0,05) 1,740
Shelf life +23°C (±2) 12 months in unopened cans
Application Dilution
Mixing ratio A+B by volume 80 parts with 20 parts
Mixing ratio A+B by weight 100 parts of Sol.A with 14 parts of Sol.B
Pot life A+B (20°C) use within 2-3 hours
Touch dry 3–4 hours (20 °C)
Spatula Ready to use
Recoat time 24-36 ore (20*)
Application temperature Between +10 C and +40 C
Relevant humidity Less than 80%
Dry film thickness advised da 1 a non oltre 10 mm per mano
Theoret. coverage m2/Lt 1 m²/litre at a thickness of 10 mm
SAFETY PRECAUTIONS

Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.

NOTES

The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.