Eliprimer 1C

Eliprimer 1C

pdf-icon

Code: 4P5241

Special one-component primer for direct application onto metals such as brass, bronze, aluminium and steel. It can be overcoated with one or two component paints and in particular, for boat propellers, with CONTENDER ELICHE antifouling. Provides excellent adhesion onto the substrate as well as for the following coats

SURFACE PREPARATION AND APPLICATION PROCEDURE METAL (BOAT PROPELLERS)

Degrease the surface with a suitable solvent (nitro, epoxy or polyurethane based. Sandblast if possible or in alternative sand with  coarse grain sandpaper (80-100 grit). The substrate should have a suitable anchor pattern. Do not use old sandpaper or wire brush as they may  cause a polished  substrate and reduce the anchor properties for the primer application. Remove dust  with a dry vacuum cleaner. Avoid touching the surface with hands in order not   to leave traces of grease or dirt which could impair the application. Apply a first  coat of ELIPRIMER 1C allowing the recommended waiting time between coats. Wait from a minimum of 4 hours to a maximum of 12 hours (20°C) and overcoat  with a first coat of CONTENDER ELICHE antifouling. Apply a second coat of CONTENDER ELICHE antifouling   within 4 hours     from the application of the previous coat. Launch  into water after a minimum of 24 hours.

Paint Type One component
Binder type A Synthetic
Specific gravity kg/lt (±0,05) 1.200
Solids content (volume) ±2 23%
Shelf life +23°C (±2) 30 months in unopened cans
Viscosity Ford (Ø4 a 20°C) 90-150 sec. (20°C)
Application Brush-Roller-Spray
Brush-Roller 5-10% Diluent 765
Spray 5-10% Diluent 765
Touch dry 60 minutes (20°C)
Recoat time Minimum 4 h Max. 12 h (20°C)
Application temperature Between +10 C and +40 C
Relevant humidity Less than 80%
Dry film thickness advised 20 microns per coat
Theoret. coverage m2/Lt 10

Colors: VERDE
Color code: 4P5241

SAFETY PRECAUTIONS

Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.



NOTES

The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.